Products > Test Equipment

DPO3000 Hacks

<< < (12/15) > >>

analogRF:

--- Quote from: Jwalling on June 02, 2015, 05:13:53 pm ---
--- Quote from: Jwalling on June 02, 2015, 05:06:46 pm ---
--- Quote from: Jwalling on June 02, 2015, 10:30:47 am ---
--- Quote from: _Sync_ on May 26, 2015, 12:05:20 pm ---I cannot get these to work and my IDA skills are too bad to figure out what is happening.

As I said in the other thread, there should also be a debug console avalible that is accessible through TCPIP but I cannot figure out how to connect to it....

--- End quote ---

Just a guess, but maybe Telnet? I have an MSO3034 -  I'll give it a try later today and see what happens.

Jay

--- End quote ---

OK, so using telnet didn't work, but using my browser (Firefox) brings up a Tektronix menu.
I selected the tab "DATA" and I'm able to talk to the scope using GPIB commands.
I then sent the following per abyrvalg's post:

:SETMODELID 5
:HWAccountant:ACQBandwidth 500

Then power-cycled the unit. It did not make any changes.
So I used the back door password first:

:PASSWord "INTEKRITY"
:SETMODELID 5
:HWAccountant:ACQBandwidth 500

Then power-cycled the unit again. Still no change. I'm probably doing something wrong; I'm an idiot when it comes to stuff like this...  :-//

Jay

--- End quote ---

OK, it's confirmed, I am an idiot.  :-/O Remove the quotes around the password:
:PASSWord INTEKRITY
:SETMODELID 5
:HWAccountant:ACQBandwidth 500

Voila, it reports that it is a MSO5054!

Thank you very much abyrvalg!  :clap: Now to do some bandwidth testing!

Jay

--- End quote ---

Was your serial number >C0200000 or less?
was the upgrade successful both in triggering, amplitude and also in doing measurements?

KrzysztofB:
I know topic is a bit old, but does anyone know if anything changed?
I was trying to unleash some serial decoding features on our old C01xxx DPO3034 to see if it would be worth purchasing it, but somehow ":ARMDEMO" seems to not work what so ever?
Anyone something about the topic?

analogRF:
Has anyone tried doing the factory adjustment on DPO3000? Is it possible to do it DIY without Fluke calibrator?

perhaps JWalling can comment on this  ;)

Jwalling:

--- Quote from: analogRF on August 01, 2022, 04:16:30 pm ---Has anyone tried doing the factory adjustment on DPO3000? Is it possible to do it DIY without Fluke calibrator?

perhaps JWalling can comment on this  ;)

--- End quote ---

I've never tried...

OYAZI:
Hello,
DPO/MSO3000
I was success that change of a model name and B/W.
Does anyone know the way to change s/n?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod