EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: bluesmoke on July 23, 2013, 01:13:02 am

Title: DS2000 Series Scope Self Calibration
Post by: bluesmoke on July 23, 2013, 01:13:02 am

Whats the correct procedure to do a self calibration on a DS2000 series scope, apart from letting it warm up 30 minutes or so?
What is confusing me is that in the manual it explains connecting the back trigger out connector to the 2 channels and trigger in but when you go to calibrate it says to make sure no signals are on the input channels!

Title: DS2000 Series Scope Self Calibration
Post by: ddavidebor on July 23, 2013, 03:06:41 am

No signal is right