Products > Test Equipment
DS2000A Upgrade Utility
<< < (22/52) > >>
AintBigAintClever:
I found (using a 32MB - yes, 32 MEGAbyte - MMC card in an SD-USB adapter) that the following would happen:-
1) Press help on bootup: SINGLE light lit
2) Plug in USB adapter with MMC card: nothing
3) Unplug USB adapter and plug it back in again: indicator on reader lights up, card starts reading, everything goes to plan.
n40:
Teneyes,

To answer your questions:
Yes there are trials enabled - I will take a shot and send it if you need that. Just let me know.
1. Yes I have done that. Only the "single" light is lit.
2. Just like adi101 said, as soon as you insert a USB (containing only the DS2000Update.GEL) the CH1 lights for just a moment (not what I'd call flashing) and then ALL of the other lights are lit solid.
3. I have tried re-inserting the USB stick and I have tried numerous different keys. No change in the symptoms. I have also left the key inserted for a "long time" (5-10mins). Again no change. I have retried the sequence 10+ times. No change.

I have tried 7 different keys now from really old 1GB devices, several 4GB and a couple modern 8GB devices. I have tested all of these USB keys using the file browser in the "storage" menu with the scope booted normally and all of the USB's seem to work fine, but I have not been able to install the older firmware's from any of them using the "help" bootloader technique.

I am keen to try out anything that you might need to get to the bottom of this.

Thanks.
theatrus:
Looks like the FileDropper links have stopped working.
Bukurat:

--- Quote from: Teneyes on July 09, 2014, 07:21:19 am ---
For the New owners of DS2072A, to help carify.
Are there Trial options on these latest purchased DS2000?

Do you observe that after pressing help on boot-up :
    1: That all LEDs go off and ONLY the "SINGLE"  is ON
    2: then when the USB stick is inserted the active led on the USB stick flashes? at least once
    3: if the USB stick Flashes only once and NO 'CH 1" flashing , try removing and re-insert.


--- End quote ---

Another new DS2072A here.

Trial options are there, 12 in total.
Software version 00.03.00.SP1
Hardware version 2.0

After pressing Help on boot:
All lights off except "Single" and "Power"
On inserting USB stick:
CH 1 light illuminates and about half a second later the other lights illuminate.
CH 1 light does NOT flash.

On continuing with the upgrade utility the next step produces an error and the error log reads

2:55:26 PM Thursday, 10 July 2014

Code length not appropriate: 12

Code: 00.03.00.SP1

Tried with two different USB sticks and both FAT 16 and FAT 32 format. Also checked the sticks can be written to by the 'scope.

Any Ideas?

John

MarcelM:
Hey Guys,

just wanted to let you know that my MSO2072A (running the very latest firmware version 00.03.00.SP1) has been successfully upgraded to 300MHz with all options.
Thanks Tirulerbach and many others!  :-+

(Although a firmware downgrade does not seem to work, using rigup on the memory dump did the trick)

Regards,
Marcel
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod