Products > Test Equipment

DS2000A Upgrade Utility

<< < (27/52) > >>

Neddie:
I'm pretty sure the upgrade utility will do that for you.

Willi100:
Did you or anybody tried that?

Willi

bnred777:
Hi everyone, I finally got my scope! Now it's time to hack it! lol... I tired to use the ds2000a upgrade utility but when it got to the part where you plugin the scope to the computer it doesn't find the DSO. I have read the forms and tried several things, including a different computer.  I downloaded the new NI Visa software just for fun and I uninstalled the upgrade utility then loaded the new Visa software for the driver, re-installed the upgrade utility and still no luck. I also made sure that the DSO was set to computer mode in utilities but I tried picbridge just for the heck of it... My software version was 2.01 before and after the loading the file from the usb stick as instructed by the program. Also, my hardware rev is 2.0. Any ideas? I did read one fourm that said to use the front USB port of the scope and set the mode to picbridge... does this sound right? The reason I haven't tried it yet is because I don't have the cable but if you guys/gals think it will work I'll buy or make one. Also, I would like to have the latest firmware version, could someone let me know what the best way of getting the latest rev and having all the options/300mhz still enabled? Just for some more info, I do have a ARM JTAG debugger (Olimex) that I could use to do it the hard way but I'm always up for the easy way first!

Thanks!

bnred777:
Hey, sorry about that. I was using USB (Rear port of the DSO). Wasn't aware you could use LAN. I have to run to town for a little while but I'll read the forum you linked to when I get back. Thanks for the reply!

adi101:
For your software version I think the utility should work.

There is always the old way of getting a memory dump:
https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg365951/#msg365951

then use the rigup 0.4 utility for getting the key:
http://www.gotroot.ca/rigol/
By the way, here you can also find the latest firmware version, which can be loaded via USB stick and the bootloader.

Then enter the key directly on the scope via Utility>Options>Setup>Editor ON.

Good luck.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod