Products > Test Equipment
DS2000A Upgrade Utility
<< < (36/52) > >>
RLSprouse:
I tried plugging the scope into my LAN via the Ethernet port but the update utility still does not see it.

I believe the utility did install the VISA driver

I don't know anything about the Ultra Sigma utility...  where do I get that?

  ~ Russ 
JDubU:

--- Quote from: RLSprouse on August 27, 2014, 01:11:02 am ---I don't know anything about the Ultra Sigma utility...  where do I get that?

--- End quote ---

http://www.rigolna.com/products/digital-oscilloscopes/mso2000a/

Select "Software" tab.
RLSprouse:
OK, I found the UltraSigma thing on the Rigol site, and I was able to install it and run it.  It appears it is able to see my scope, though I have no idea what to do with it, but at least the scope is inline and apparently recognized.

So, for some reason, the utility seems to be having a problem seeing my scope in spite of it being properly connected.

Any more ideas?

  ~ Russ 

RLSprouse:
I was finally able to unlock my DS2072A-S, using a hybrid approach.  The utility refused to recognize my scope when I plugged it into the USB port, so I completed the rest of the process manually, using the guide found here:

http://gotroot.ca/rigol/D2072A%20Unlocking%20Guide.pdf

I elected to go with the 200MHz option, plenty fast for my needs.  All options unlocked.  Happy camper!

The only problem I have now is that the CH1 vertical position knob does not work.  I don't know if that has anything to do with all this firmware hacking or not.  I may have to return the scope for service.

  ~ Russ 
ReadNoise:
I had a similar problem as many others with the SW 03.00.SP1 and HW 2.0 DS2072A, it refuses to load any older firmware while re-flashing the current version works just fine. As I read further on other threads, I came across https://www.eevblog.com/forum/testgear/rigol-mso2000-series-hacking/ thread and especially the discussion using the SCPI command :SYST:UTIL:READ? to get a memory dump.


--- Quote from: PepeK on September 08, 2014, 07:13:24 pm ---I can confirm, the command  ":SYST:UTIL:READ? 15441920, 13262848" works perfectly on my MSO 2072 A. The scope is connected via Lan cable.
SW 3.0.SP1
HW 2.2
The rigup.exe tool generates keys in miliseconds.

--- End quote ---

I used NCat to get the partial memory dump (address range likely varies between SW versions) from the scope, ran the rigup.exe included in the DS2000A upgrade utility, and it created the keys for my DS2072A. Sent the 200MHz key to scope with netcat again and 200MHz was unlocked. Total time start to finish was under 2 minutes.


echo :SYST:UTIL:READ? 15441920,13262848 | ncat -i 1 SCOPE_ADDRESS_HERE 5555 > DS2072A_sdram.bin
rigup scan DS2072A_sdram.bin > EC-keys.txt
rigup DS2072 DS2072A_sdram.bin > Options.txt
type Options.txt
echo :SYST:OPT:INSTALL A_KEY_FROM_OPTIONS_WITHOUT_DASHES | ncat -i 1 SCOPE_ADDRESS_HERE 5555


--A
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod