Products > Test Equipment
DS2000A Upgrade Utility
madcrow:
========UPDATE========
=====================
I am happy to announce that the connection issue reported by Noircogi and Kappes Buur is now completely fixed.
I performed all my recent tests on a WIN8.1 x64 VM, so now I can also confirm that the Utility is fully compatible with Win8[.1].
I also thoroughly tested (and then updated) the install / uninstall mechanism.
The new release along with the changelog is available in the OP.
Have fun :)
hari:
the tool itself seems to be a nice job, but I also think that lowering the effort for the hack that much puts even more pressure on Rigol to prevent such hacks in the future. My 2c.
Kappes Buur:
========UPDATE======== worked perfectly. Thank you.
My two cents worth on if this is good or bad in the long run.
From what I can tell, the DS2072A is just flying off the shelf, at least at Tequipment.
They seem to buy them in 100 lots and within a few weeks they are gone. I doubt
very much, that this kind of sales turnover could have been achieved without the
possibility of an easy upgrade.
If this had not been investigated as thoroughly as indicated in the 'Sniffing' thread,
most likely some other, lower priced oscilloscope, would have been more popular.
BTO:
@madcrow
sorry mate, Stupid Question
I had the same issue with the USB Connection Not Detecting
i know you said the fix was available at the OP
i didn't understand what you meant by that
I'm assuming i need to re download the Standard Edition with Installer from this location again
https://www.eevblog.com/forum/testgear/ds2000a-upgrade-utility/
and then repeat the process ??
i did that, However the file is the same and i get the same issue
is there another location i should be getting the file from
I'll keep a keen eye on this Forum and Await your reply
thanks again, in advance.
BTO:
For the Sake of Troubleshooting and Further to my issue of Running the Application and not having the DS2072A Detect at the "Connect to DS2000A to your computer" STAGE
I've checked my Drivers
I"m using Windows 7 Ultimate 64bit with Service Pack 1
I've checked Device Manager and under "Portable Devices" DS2072A is listed as having the Driver Successfully installed
and
thus explaining why When i plug in the DSO to USB it will Automatically detect
I Tried Manually installing the Nivisa Package , since i know it has the Drivers in the package
this did not help the issue
I checked the Directory location
{install location}\Temp since the process did not complete, this location does not contain any error Logs
I checked the Installers Folder and the NiVisa .txt File there's a lot there
but.. i don't think there are any errors
What do you suggest i do next
i think what you meant by OP, may have been O.P. = Original Post (just guessing)
i did go to the Original Post and found a Second Link but that didn't help much either
PS, is there something i'm supposed to do with the Changelog file, i don't clearly understand what the ChangeLog File is for
i do However understand what the purpose of the Portable Version is .
Awaiting you reply
thanks ahead of time
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version