Products > Test Equipment
DS2000A Upgrade Utility
BloodyCactus:
just ran this against my new ds2072a, everything worked, shows up as DS2302A, all options enabled. shipped with firmware 00.02.xx, upgraded to 00.03.xx.
two thumbs up!
johnlondon:
I've just tried this with my DS2072A running 00.03.00.SP1 and I got no flashing lights after inserting the USB stick, nothing at all. The DSO won't boot up at all now, it just starts with a Rigol logo (no progress bar on boot at all). Any ideas as to how I can unblock it please?
marmad:
--- Quote from: johnlondon on June 17, 2014, 11:41:04 am ---I've just tried this with my DS2072A running 00.03.00.SP1 and I got no flashing lights after inserting the USB stick, nothing at all. The DSO won't boot up at all now, it just starts with a Rigol logo (no progress bar on boot at all). Any ideas as to how I can unblock it please?
--- End quote ---
Just reload FW v.2 at bootup.
johnlondon:
Fixed the issue with the bricked DS2072A. It involved reflashing it with the latest firmware (from this site) as you suggested, then attempting it again. All good now. Thank you for my new scope :-)
rmawatson:
Many thanks. Just bought a 2072A after finding out about the ability to upgrade to 300mhz.
Worked like a charm. all options enabled. Screen shots attached for others reference of FW/SW versions.
One note about the (extremely nice and helpful) UI. On the page where it says "when channel 1 stops flashing.." this should say, you might have to wait a few minutes.
It was long enough that I thought i'd potentially got a new door stop :)
Thanks again!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version