EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: Circlotron on December 08, 2017, 12:49:56 am

Title: DS2072 event table "details" tab, how to open?
Post by: Circlotron on December 08, 2017, 12:49:56 am

The tab in the screen shot, how do you open it?
It doesn't seem to be mentioned in the user guide.
Firmware is 00.03.05.SP3

Title: Re: DS2072 event table "details" tab, how to open?
Post by: CustomEngineerer on December 08, 2017, 03:02:34 am

Pretty sure its only available when you are decoding specific busses. Can't remember for sure, but think it was only if decoding CAN. Try changing decode type to CAN, then open the event table, and press the View button to change to the Details tab.

Edit: Actually, I know I've used it for I2C decoding before too. Checking the user guide also confirms its available for CAN (Fig. 8-14) & I2C (Fig. 8-7) decoding.