Products > Test Equipment

DSlogic Plus Pango Version (2023)

<< < (7/10) > >>

ahmad_k:
Here is the updated version, DSVIEW added support for the new model 3 weeks ago only, I didn't noticed before

https://mega.nz/file/lMMCDb7B#Qkijv6RLoQ58YqhfcU2jsu8E06duzLA4iz9WXvl1kgQ

godor2008:
Here are photos of PCB

ahmad_k:
Yes, this is a new hardware revision. First PANGO model was labeled v421 on PCB back side. This is v511

godor2008:
So I got new EEPROM, programmed it and soldered. DSView shows it correct. But when I try to read contents using your utility, it fails:

--- Code: ---fx2lafw_eeprom_loader.exe -t M24128 -r test_read.hex
EEPROM is M24128 (16384 bytes)
EEPROM action is Read
Found PID = 0x2A0E, VID = 0x0035, 'DSLogic U2Basic (PANGO) V2'
Error: Failed to open hex file for reading 'Vend_Ax.hex'

fx2lafw_eeprom_loader.exe -t 24LC128 -r test_read.hex
EEPROM is 24LC128 (16384 bytes)
EEPROM action is Read
Found PID = 0x2A0E, VID = 0x0035, 'DSLogic U2Basic (PANGO) V2'
Error: Failed to open hex file for reading 'Vend_Ax.hex'
--- End code ---

I also tried it with short circuiting pin 4 and 7 to enable Write, but result same for reading

ahmad_k:
sorry, this is the file:

https://mega.nz/file/NAcykAxS#y3JfGSuLK7zj2MbSng9dHL-wWUf74j1YkzPNMqYGOjc

put it next to the exe

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod