Products > Test Equipment
DSlogic Plus Pango Version (2023)
godor2008:
Great! I was able to read firmware.
God bless you man!
godor2008:
I finally installed W9825G6KH-6 RAM and changed 35 to 34 code in EEPROM. After it, my U2Basic started perfectly working as U2Plus without any spikes. Here is modified EEPROM for usage with fx2lafw_eeprom_loader
alvideo:
--- Quote from: godor2008 on July 02, 2024, 10:57:10 am ---Here are photos of PCB
--- End quote ---
I have identical DSLogic Basic PCB ver. 511 with Pango
A12 signal by default wiring to Pango.
To upgrade to PLUS version only need:
Modify in eeprom ID from 35 to 34.
Changed flash to AS4C16M16SA-7TCN.
Now in Dsview works as DSLogic Plus.
Aleksandr:
PCB ver. 431 with Pango. Converted to plus version, installed W9825G6KH-6 RAM, changed in the firmware from 0x31 to 0x30. Everything is working. I tried installing AS4C16M16SA-6TIN RAM, it didn’t work, graphs were not displayed correctly.
Delta213:
Mine is 437 version, same as pic before. I replaced W9864G6KH-6 RAM on W9825G6KH-6, also 1990>30, so DSL become plus version, it worked for about 5 min, but later instead of data he shows garbage.
When its not connected it shows this
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version