Products > Test Equipment
DSlogic Plus Pango Version (2023)
RoGeorge:
DSlogic Pro w Xilinx FPGA didn't work very well either with the generic Sigrok+Pulseview. Sigrok is the command line part, Pulseview is the GUI on top of Sigrok.
However, the DSview offered by DreamSourceLab works very well with any DSlogic hardware. DSView is a customized Sigrok+Pulseview. Anything about Sigrok or Pulseview applies to DSView, too. They offer DSview installers for all major OSs, and DSView is open source, too. https://github.com/DreamSourceLab/DSView
I don't have the Pango hardware, but I assume its software is the same story. Why do you need Sigrok, isn't Sigrok included in the DSview for Pango already?
SpoonMan:
What do you mean with "isn't Sigrok included in the DSview for Pango already"? Included?
Ok, I don't want to trigger again the controversial about DSLab guys stole Sigrok+Pulseview to start their SW, I just would like to use Sigrok+Pulseview to have the ability of using "one software for all", Hantek DSO + DSLogic LA. Also having the ability to start sessions at the same time would be a nice to have feature.
RoGeorge:
My mistake, sorry. I've just tried on a clean Ubuntu VM, and Sigrok is still part of the latest DSview, just that it is not exposed to the end user.
At best, you can install both DSView to use with DSLogic, and another standalone Sigrok install for oscilloscope. Last time when I've tried Sigrok with Pulseview (for DSlogic), it was working, but with lots of hiccups, it was not fully usable. After spending some hours trying to make it work properly, I've give up, and since then using DSView instead.
SpoonMan:
Maybe someone of you has some experience in development of HW support for Sigrok?
It would be interesting to develop support for such new Pango-based devices in Sigrok, any hint to kickstart in is then appreciated.
Navigation
[0] Message Index
[*] Previous page
Go to full version