Products > Test Equipment

DSView 1.3.0 - How to group channels into buss

(1/1)

paults1956:
The manual doesn't mention this AT ALL. I've tried clicking/dragging/chanting spells but nothing. What am I missing?? All I want is an 8-bit data buss and a 16-bit address showing the HEX values as my 8031 board runs BASIC from an EPROM.

abeyer:
I think you want to add a parallel protocol decoder w/ your data and clock lines assigned in the config for the decoder. DSView is a custom build of the sigrok software, so you can always look at their docs for general reference, too, although there are minor differences.

paults1956:
Thanks! That was the method. Sure would HELP if it was mentioned in the manual.  |O

asis:
Hi,

If you are working with DSLogic 16, you will have to divide its resource in half.
That is, the first 8 bits are allocated to the address, using the zero bit for triggering, and the remaining 8 bits for data.
You should follow the connection sequence - address/data bit size so as not to mislead yourself.
Just practice in demo mode.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod