| Products > Test Equipment |
| Dual channel multimeter or another option? |
| << < (5/8) > >> |
| bdunham7:
--- Quote from: tautech on December 07, 2022, 07:35:27 pm ---A feature you don't know of in these is the new Probe Check when a probes through input is compared against the probe compensation output and a custom attenuation applied to increase accuracy. bdunham7, can you be educator on this subject seeing you have your scope turned ON ? --- End quote --- I don't see the Probe Check feature anywhere. Comparing CH1 1X and CH2 10X there's very, very little difference. The probe does load the calibrator down a bit, makes a about a 500ppm difference. My DMMs load it down even more, which you'd expect. So the calibrator source impedance isn't very low. |
| Stray Electron:
Fluke model 45. I don't know if they still make them or not but they've been around a while and I'm sure you can find one on E-Greed. Like most Fluke meters, it's a very good meter and not a hunk of junk. https://www.tequipment.net/Fluke45.html#description |
| tautech:
--- Quote from: bdunham7 on December 08, 2022, 12:02:41 am --- --- Quote from: tautech on December 07, 2022, 07:35:27 pm ---A feature you don't know of in these is the new Probe Check when a probes through input is compared against the probe compensation output and a custom attenuation applied to increase accuracy. bdunham7, can you be educator on this subject seeing you have your scope turned ON ? --- End quote --- I don't see the Probe Check feature anywhere. --- End quote --- Really, well OK let's show you some new tricks. Channel menu> Input attenuation> Probe check......it's in the latest firmware and not sure when it was implemented as can't yet find it in Release notes. |
| bdunham7:
--- Quote from: tautech on December 08, 2022, 12:47:19 am ---Really, well OK let's show you some new tricks. not sure when it was implemented as can't yet find it in Release notes. --- End quote --- I'm on 1.3.9R6 and haven't updated because I didn't see anything worthwhile in the release notes. I don't have that feature. |
| tautech:
--- Quote from: bdunham7 on December 08, 2022, 01:21:34 am --- --- Quote from: tautech on December 08, 2022, 12:47:19 am ---Really, well OK let's show you some new tricks. not sure when it was implemented as can't yet find it in Release notes. --- End quote --- I'm on 1.3.9R6 and haven't updated because I didn't see anything worthwhile in the release notes. I don't have that feature. --- End quote --- :-// Best your read the V1.5.2R1 release notes again. Sure there's a small bug in the time region setting but it can be worked around with a UTC setting or I have a beta without that bug. |
| Navigation |
| Message Index |
| Next page |
| Previous page |