Products > Test Equipment

Dual channel multimeter or another option?

<< < (5/8) > >>

bdunham7:

--- Quote from: tautech on December 07, 2022, 07:35:27 pm ---A feature you don't know of in these is the new Probe Check when a probes through input is compared against the probe compensation output and a custom attenuation applied to increase accuracy.

bdunham7, can you be educator on this subject seeing you have your scope turned ON ?

--- End quote ---

I don't see the Probe Check feature anywhere.  Comparing CH1 1X and CH2 10X there's very, very little difference.  The probe does load the calibrator down a bit, makes a about a 500ppm difference.  My DMMs load it down even more, which you'd expect.  So the calibrator source impedance isn't very low.

Stray Electron:
  Fluke model 45.  I don't know if they still make them or not but they've been around a while and I'm sure you can find one on E-Greed. Like most Fluke meters, it's a very good meter and not a hunk of junk.

https://www.tequipment.net/Fluke45.html#description

tautech:

--- Quote from: bdunham7 on December 08, 2022, 12:02:41 am ---
--- Quote from: tautech on December 07, 2022, 07:35:27 pm ---A feature you don't know of in these is the new Probe Check when a probes through input is compared against the probe compensation output and a custom attenuation applied to increase accuracy.

bdunham7, can you be educator on this subject seeing you have your scope turned ON ?

--- End quote ---

I don't see the Probe Check feature anywhere. 

--- End quote ---
Really, well OK let's show you some new tricks.

Channel menu> Input attenuation> Probe check......it's in the latest firmware and not sure when it was implemented as can't yet find it in Release notes.

bdunham7:

--- Quote from: tautech on December 08, 2022, 12:47:19 am ---Really, well OK let's show you some new tricks.
not sure when it was implemented as can't yet find it in Release notes.

--- End quote ---

I'm on 1.3.9R6 and haven't updated because I didn't see anything worthwhile in the release notes.  I don't have that feature. 

tautech:

--- Quote from: bdunham7 on December 08, 2022, 01:21:34 am ---
--- Quote from: tautech on December 08, 2022, 12:47:19 am ---Really, well OK let's show you some new tricks.
not sure when it was implemented as can't yet find it in Release notes.

--- End quote ---

I'm on 1.3.9R6 and haven't updated because I didn't see anything worthwhile in the release notes.  I don't have that feature.

--- End quote ---
:-//
Best your read the V1.5.2R1 release notes again. Sure there's a small bug in the time region setting but it can be worked around with a UTC setting or I have a beta without that bug.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod