Products > Test Equipment
E36300 Series Programmable DC Power Supplies (E36311A, E36312A, E36313A)
pmcouto:
--- Quote from: rsjsouza on December 22, 2017, 04:18:55 pm ---I am not sure if this is just my impression or not, but last night I entered my lab space (the laundry room) with the lights out and it seemed that my E36312A had the TFT backlight on with the power supply off.
It may have been the reflection of the yellow standby LED, but the dim glow looked too evenly distributed across the display.
Does anybody else see this?
--- End quote ---
Yes!
The backlight is not fully on, but there's a faint light coming from the display when the PSU is in standby.
nctnico:
Can someone test whether this has fixed the startup issues?
@Daniel: thanks for making this available! I hope everything goes well and your new born is healthy. If it is the first: be sure to be there when it is born. If it is not then you probably already know that you need to be there when the magic happens ;)
HighVoltage:
Thanks Daniel and congratulations!
I wish you all the best but especially good health for the newborn and the mother.
I am updating the firmware right now and then will run a few tests
HighVoltage:
The Firmware update went smooth from FW 1.04 to FW 1.08 with the PC firmware utility.
HighVoltage:
Ok, here are the results.
Not so good, when power is switched ON, on the mains level, these are the results:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version