Products > Test Equipment
E36300 Series Programmable DC Power Supplies (E36311A, E36312A, E36313A)
<< < (29/54) > >>
Dubbie:
this forgetfulness would bug the crap out of me.
I have my rigol set up in a way that I use 80% of the time. Usually, I can just flick the power switch then enable the output. It would infuriate me if I had to dial it in every single time.
nctnico:

--- Quote from: Dubbie on February 06, 2018, 07:52:50 pm ---this forgetfulness would bug the crap out of me.
I have my rigol set up in a way that I use 80% of the time. Usually, I can just flick the power switch then enable the output. It would infuriate me if I had to dial it in every single time.

--- End quote ---
You can set the default the way you like it (and have 10 presets) so if you mostly use 5V you can have that as a default.
pe1oxp:

--- Quote from: Keysight DanielBogdanoff on December 23, 2017, 06:57:16 am ---Hi Everyone,

Good news, I have beta code with some fixes: http://bit.ly/E3631x_Beta

Use at your own risk! It hasn't been fully QA tested, and I haven't even able to test it myself since I'm on Christmas break.

I also don't have a change log yet, I'm working on getting one. If by some chance you end up with a fatal error, please post here and message me so we can handle it.

Official code is scheduled for February. I'll do my best to get a change log, but am also expecting a new kiddo any day now so life might get crazy fast :).

Thanks!

--- End quote ---

Any news about the expected new firmware?
Received my power supply with the 'old' firmware.
pe1oxp:
Anyone tried the new firmware on the Keysight website?
Version 1.1.1-1.0.2-1.05 from 26 Feb 2018

Bug Fixes
• Fixed knob inconsistency issue
• Fixed store/recall issues
• Fixed relay state after power cycle (E3631A Persona Mode)
• Fixed incorrect configuration on series mode
• Fixed unit hung issues

Enhancements
• Added Multiple Languages help (French, German, Japanese, Korean, Chinese, and Russian)
• Enhanced SCPI datalog fetch command parameter to support up to 65536
• Enhanced front panel to run LIST when trigger source set to IO
bitseeker:
Hmm, nothing about the excessive power consumption when "off."
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod