Products > Test Equipment
East tester ET432 vs Der EE DE-5000 Comparison
<< < (5/9) > >>
NoMoreMagicSmoke:

--- Quote from: Martin72 on May 20, 2023, 10:34:06 pm ---It annoys me a bit right now that I don't have the ET4410 anymore....
At that time I had only measured capacitors and coils with it.

--- End quote ---

Truly a bummer. I am also interested in how the higher end ET4410 handles this.
Martin72:
I´m thinking about to get this thing back for several reasons(finishing the circuit diagram I´ve started to draw, doing comparisons vs my hioki lcr).
It was a good one, slightly "better" than the DE5000 with more features.
NoMoreMagicSmoke:

--- Quote from: Martin72 on May 21, 2023, 12:26:21 am ---I´m thinking about to get this thing back for several reasons(finishing the circuit diagram I´ve started to draw, doing comparisons vs my hioki lcr).
It was a good one, slightly "better" than the DE5000 with more features.

--- End quote ---

How was it "better" than the DE?
NoMoreMagicSmoke:
Update after talking to the ET432 vendor.

They sent me a replacement set of Kelvin clips, and they now measure ESR the same as the DE-5000. The vendor also confirmand that their testing showed that the ET432 is out of specification when measuring a 20K resistor at 100KHz (and gets worse as the resistance goes up). They said that the engineer was investigating, and they would let me know once they have a resolution.
pope:
Would be interesting to hear what the say.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod