Products > Test Equipment

East tester ET432 vs Der EE DE-5000 Comparison

<< < (5/9) > >>

NoMoreMagicSmoke:

--- Quote from: Martin72 on May 20, 2023, 10:34:06 pm ---It annoys me a bit right now that I don't have the ET4410 anymore....
At that time I had only measured capacitors and coils with it.

--- End quote ---

Truly a bummer. I am also interested in how the higher end ET4410 handles this.

Martin72:
I´m thinking about to get this thing back for several reasons(finishing the circuit diagram I´ve started to draw, doing comparisons vs my hioki lcr).
It was a good one, slightly "better" than the DE5000 with more features.

NoMoreMagicSmoke:

--- Quote from: Martin72 on May 21, 2023, 12:26:21 am ---I´m thinking about to get this thing back for several reasons(finishing the circuit diagram I´ve started to draw, doing comparisons vs my hioki lcr).
It was a good one, slightly "better" than the DE5000 with more features.

--- End quote ---

How was it "better" than the DE?

NoMoreMagicSmoke:
Update after talking to the ET432 vendor.

They sent me a replacement set of Kelvin clips, and they now measure ESR the same as the DE-5000. The vendor also confirmand that their testing showed that the ET432 is out of specification when measuring a 20K resistor at 100KHz (and gets worse as the resistance goes up). They said that the engineer was investigating, and they would let me know once they have a resolution.

pope:
Would be interesting to hear what the say.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod