Products > Test Equipment
East Tester ET5410 ET5420 ET5411 ET54 series - Software
<< < (3/11) > >>
SPAZIONICA:
Hello Everybody,

I'm writing a software for the ET5410,

I am having these problems:

1) When switched on, the ET5410 is set in Chinese language also if Star Set is "Last", however through the software with the command <SYSSet:LANGuage ENGLISH> I can set to English

2) After about 20,000 readings using the command <MEAS:VOLTage?> the ET5410 no longer responds, while other command example <*IDN?> works

I noticed also that in the command set is not present a reset command, example <*RST> is present in all the SCPI instruments that up to now I have used with the PC

I'm afraid it's a firmware issue, I'm trying to contact support and I hope they answer me soon,

any suggestions ?

Best Regards

SPAXIO
HKJ:

--- Quote from: SPAZIONICA on July 02, 2022, 03:53:36 pm ---I'm writing a software for the ET5410,

2) After about 20,000 readings using the command <MEAS:VOLTage?> the ET5410 no longer responds, while other command example <*IDN?> works

--- End quote ---

You can try TestController https://www.eevblog.com/forum/testgear/program-that-can-log-from-many-multimeters/ and see if it has the same problem.
SPAZIONICA:
Hi HKJ,

now I'm away from the instrument, and remotely I can't turn it off and on again,

anyway in the next few days I will try with Testcontroller and let you know

Many Thanks!

SPAXIO
SPAZIONICA:
I tried remotely but nothing to do also with TestController behaves the same way, see attached screen shot,

Many Thanks for introducing me to TestController :-+

SPAXIO

HKJ:

--- Quote from: SPAZIONICA on July 02, 2022, 04:53:42 pm ---I tried remotely but nothing to do also with TestController behaves the same way, see attached screen shot,

Many Thanks for introducing me to TestController :-+

--- End quote ---

Strange, try selecting the "Current values" tab.

I have not made the definition for this device, but I am pretty sure that jmurray had it working before posting it. Of course the protocol may have changed, Easy Tester do that sometimes.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod