Products > Test Equipment

East Tester ET5410 ET5420 ET5411 ET54 series - Software

<< < (3/11) > >>

SPAZIONICA:
Hello Everybody,

I'm writing a software for the ET5410,

I am having these problems:

1) When switched on, the ET5410 is set in Chinese language also if Star Set is "Last", however through the software with the command <SYSSet:LANGuage ENGLISH> I can set to English

2) After about 20,000 readings using the command <MEAS:VOLTage?> the ET5410 no longer responds, while other command example <*IDN?> works

I noticed also that in the command set is not present a reset command, example <*RST> is present in all the SCPI instruments that up to now I have used with the PC

I'm afraid it's a firmware issue, I'm trying to contact support and I hope they answer me soon,

any suggestions ?

Best Regards

SPAXIO

HKJ:

--- Quote from: SPAZIONICA on July 02, 2022, 03:53:36 pm ---I'm writing a software for the ET5410,

2) After about 20,000 readings using the command <MEAS:VOLTage?> the ET5410 no longer responds, while other command example <*IDN?> works

--- End quote ---

You can try TestController https://www.eevblog.com/forum/testgear/program-that-can-log-from-many-multimeters/ and see if it has the same problem.

SPAZIONICA:
Hi HKJ,

now I'm away from the instrument, and remotely I can't turn it off and on again,

anyway in the next few days I will try with Testcontroller and let you know

Many Thanks!

SPAXIO

SPAZIONICA:
I tried remotely but nothing to do also with TestController behaves the same way, see attached screen shot,

Many Thanks for introducing me to TestController :-+

SPAXIO

HKJ:

--- Quote from: SPAZIONICA on July 02, 2022, 04:53:42 pm ---I tried remotely but nothing to do also with TestController behaves the same way, see attached screen shot,

Many Thanks for introducing me to TestController :-+

--- End quote ---

Strange, try selecting the "Current values" tab.

I have not made the definition for this device, but I am pretty sure that jmurray had it working before posting it. Of course the protocol may have changed, Easy Tester do that sometimes.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod