EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: snoozer on September 15, 2019, 01:40:12 pm

Title: EEVBlog 121GW Bench Stand (3D Printed)
Post by: snoozer on September 15, 2019, 01:40:12 pm

Hi,

thought I share my 121GW bench stand design in case others might find it useful. I wanted the angle a little lower then the original build in stand and since I am almost exclusively use it on the bench I also wanted it a bit wider to prevent accidental fall over. Have to add some rubber pads to the bottom to prevent it from slipping around but should be fine then.

Thingiverse link:
https://www.thingiverse.com/thing:3862923 (https://www.thingiverse.com/thing:3862923)

Fusion 360 link:
https://a360.co/31q8WmW (https://a360.co/31q8WmW)

Have FuN!
Jan P.

Title: Re: EEVBlog 121GW Bench Stand (3D Printed)
Post by: coromonadalix on September 15, 2019, 01:42:53 pm

Nicely done  :-+