Products > Test Equipment

EEVBlog 121GW Discussion thread

<< < (405/411) > >>

EEVblog:

--- Quote from: J-R on January 21, 2024, 01:53:12 pm ---If you can't read German, you could buy them from Dave:
https://eevblog.store/products/brymen-bl21s2-t4sc-gold-plated-silicone-test-probes

--- End quote ---

I also sell them on Amazon:
https://www.amazon.com/EEVblog-Brymen-BL21S2-T4SC-Plated-Silicone/dp/B0CQH1CXR6/ref=sr_1_1

TrickyT:

--- Quote from: EEVblog on January 29, 2024, 12:30:38 am ---
--- Quote from: TrickyT on January 27, 2024, 12:10:48 am ---My function switch has become flaky and I need to know if the shim and replacement knob are still available and, if so, where do I get them. I was part of the original Kickstarter project and my meter was one from the 2nd production batch. (I received it in August 2018, s/n 1418) I didn't pursue obtaining the shim and knob when the switch problem first starting appearing because my meter was working fine and I figured that the thickness tolerance on my PC board must have been such that my meter was not one of those affected. But things have gradually gotten worse to the point where now the meter only powers up if I mess with the function switch a bunch of times. Maybe the springs in switch contacts have lost some oomph or something else has worn. Anyway it would be great to source the updated knob and shim now and any help from this forum would be appreciated.

--- End quote ---

I've got a few left, email me your postal address.

--- End quote ---

Done.  And thanks!

AVGresponding:

--- Quote from: J-R on January 21, 2024, 12:07:51 pm ---Only 10.90 € for a complete new set:
https://www.welectron.com/Brymen-BL21S2-T4SC-Silicone-Test-Leads

--- End quote ---

Yes, but I'm cheap!

PhilipG:
I'm new here, but I have a 121GW with firmware 2.05.  Can anyone tell me how to turn the beeper off when making low resistance measurements?

BILLPOD:
Page 61 of the manual:
Last Revised: 1 March 2020 121GW User Manual

BUZZER ON/OFF
If you wish to disable/enable the buzzer to perform the following steps:
1. Navigate to the b-OFF or b-ON menu item using the SETUP button.
2. Press and hold SETUP, until display flashes.
3. Press UP/DOWN to toggle between “b-OFF” and “b-ON”.
4. To save the setting press and hold SETUP, until display no longer
flashes. :popcorn:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod