Products > Test Equipment
EEVBlog 121GW Discussion thread
J-R:
--- Quote from: PhilipG on February 02, 2024, 09:16:13 am ---I'm new here, but I have a 121GW with firmware 2.05. Can anyone tell me how to turn the beeper off when making low resistance measurements?
--- End quote ---
The 121GW doesn't beep during low resistance measurements unless you have the continuity mode selected. "b-OFF" and "b-ON" do not apply to continuity mode.
So it sounds like you need to switch from continuity mode to resistance mode.
VEGETA:
i tried putting it in cart but it says it does not ship to my address, my address is Jordan - Irbid - ZIP code 21110.
also, when bought does it come in a bag or what?
Wrenches of Death:
I picked up a new 121GW a while back. It's a recent one, built in 2024. So far, so good. It's an interesting meter.
I backed up the calibration to SD card, copied it to one of my Linux computers and attempted to view it without success.
The meter is running under 2.05. I downloaded the "cal_decode.py" script and executed it under Python version 3.10.12 and the process failed. The result was unformatted garbage.
Any ideas?
Thanks in advance,
WoD
FOUND IT!
It works fine when saving the data to a different SD card. I did a full format of the original card and tried it again with the same results. What ever the problem is, it isn't showing up during format on a Win7 or on a Linux box. The 32G SD card that came with the meter has a problem.
Hopefully it isn't a write issue with the meter itself.
WoD
BAD SD card!
The meter saves the cal data just fine with three other cards and the python script decodes them all properly.
If this was a computer, I'd throw it off of the roof into the parking lot. :-)
WoD
VEGETA:
--- Quote from: VEGETA on March 22, 2024, 05:47:22 pm ---i tried putting it in cart but it says it does not ship to my address, my address is Jordan - Irbid - ZIP code 21110.
also, when bought does it come in a bag or what?
--- End quote ---
anyone can help? the site rejects my address.
EEVblog:
--- Quote from: VEGETA on March 26, 2024, 09:34:03 pm ---
--- Quote from: VEGETA on March 22, 2024, 05:47:22 pm ---i tried putting it in cart but it says it does not ship to my address, my address is Jordan - Irbid - ZIP code 21110.
also, when bought does it come in a bag or what?
--- End quote ---
anyone can help? the site rejects my address.
--- End quote ---
Jordan is a Zone 7 country, shipping costs almost as much as the meter does. I don't ship beyond Zone 5.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version