| Products > Test Equipment |
| EEVBlog 121GW Discussion thread |
| (1/411) > >> |
| plexus:
I searched the forum and coulnd't find an appropriate general purpose 121GW thread. So here it is! Question: what are the various straps in the case to be used for? I can't figure them out. Here is an unboxing video I made today when mine arrived: I'll be RTFM now that I have played around with it a bit. It's a very nice meter so far. Feels well built! |
| Mr.B:
I don't have mine yet. I will be in wave 2 of the shipping (March?). My question: The manual specifically says: Battery Type: 4 x 1.5 V AA alkaline battery (ANSI/NEDA 15 A or IEC LR6) Can anyone (Dave) confirm if it is safe to use the slightly higher voltage Energizer L91 Ultimate Lithium http://data.energizer.com/pdfs/l91.pdf Many thanks |
| beanflying:
Quick Capacitance check on mine against my HP box. Does that very close 😎 |
| beanflying:
Quick resistance check against my 0.02% (1ohm 0.03%) Resistance box. Temp is 25-26 degrees btw. It does ok below 1 ohm but that territory isn't fair on two wire so just 1 ohm and up was all I have included. Also tested against some Vishay 0.005% (some pairs) I have 'laying' around ::) 10k 9.999k 10k 10.000k 500R 0.5000k 500R 0.5000k 100R 100.05 5k 5.000k |
| knapik:
I just got mine earlier today. I'm pretty happy with it so far, but I haven't really gave it any purposeful use yet. In regards to the question about the straps, I'm pretty sure they're for securing the multimeter and leads like this. I also see that there's another strap on the back, Dave must have liked that multimeter strap patent so much, that he wanted one too ;) |
| Navigation |
| Message Index |
| Next page |