Products > Test Equipment
EEVBlog 121GW Multimeter Firmware Details
<< < (40/62) > >>
HKJ:

--- Quote from: Terry01 on December 06, 2018, 05:38:54 pm ---Yes, just did it again and also with my 87v too. The Fluke did it no probs and the 121GW showed OFL. I used a half-"ish" used 9v battery and a 4 ohm power resister as a load.

--- End quote ---

You are aware that maximum for mA input range is 55mA on the 121GW, for larger current you must use the A input.
Terry01:
Well there's why it won't measure 90 mA in the mA range then!   :-DD
HKJ:

--- Quote from: Terry01 on December 06, 2018, 05:50:05 pm ---Well there's why it won't measure 90 mA in the mA range then!   :-DD

--- End quote ---

That is part of the "Low burden voltage", the high mA range is moved to the A input.

It is not that the meter is missing a range, it has one or two current ranges more than most other multimeters. It has 7 current ranges, typically a meters has 5 or 6 current ranges.
Terry01:

--- Quote from: HKJ on December 06, 2018, 06:40:23 pm ---
--- Quote from: Terry01 on December 06, 2018, 05:50:05 pm ---Well there's why it won't measure 90 mA in the mA range then!   :-DD

--- End quote ---

That is part of the "Low burden voltage", the high mA range is moved to the A input.

It is not that the meter is missing a range, it has one or two current ranges more than most other multimeters. It has 7 current ranges, typically a meters has 5 or 6 current ranges.

--- End quote ---

Cool, thanks for the information. I would never have guessed that as there is no indication on the meter around the jacks and I haven't read the manual.

Thanks again  :-+
HKJ:

--- Quote from: Terry01 on December 07, 2018, 02:44:22 pm ---
Cool, thanks for the information. I would never have guessed that as there is no indication on the meter around the jacks and I haven't read the manual.

--- End quote ---

There is a indication, the A terminal is marked "A 500mA", because it is both ampere and 500mA range.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod