Products > Test Equipment
EEVBlog 121GW Multimeter Firmware Details
bicycleguy:
--- Quote from: n3mmr on December 10, 2018, 01:13:46 pm ---A question about logging:
Is it possible to log both frequency and voltage simultaneously in ac mode and automatic logging?
--- End quote ---
yes
--- Code: ---START 2018/12/10 10 21 24
ID 170800121
INTERVAL 10 sec
MAIN SUB-1 SUB-2 Remark
No. Func. Value Unit Func. Value Unit Func. Value Unit
1 ACV 0.0046 V FREQ. 0 Hz
2 ACV 0.0114 V FREQ. 0 Hz
3 ACV 0.0122 V FREQ. 0 Hz
4 ACV 0.027 V FREQ. 0 Hz
5 ACV 0.0413 V FREQ. 0 Hz
6 ACV 0.2659 V FREQ. 59.996 Hz
7 ACV 0.2724 V FREQ. 59.999 Hz
8 ACV 0.0245 V FREQ. 0 Hz
MAX 7 ACV 0.2724 V
MIN 1 ACV 0.0046 V
--- End code ---
n3mmr:
--- Quote from: bicycleguy on December 10, 2018, 05:25:50 pm ---
--- Quote from: n3mmr on December 10, 2018, 01:13:46 pm ---A question about logging:
Is it possible to log both frequency and voltage simultaneously in ac mode and automatic logging?
--- End quote ---
yes
--- Code: ---START 2018/12/10 10 21 24
ID 170800121
INTERVAL 10 sec
MAIN SUB-1 SUB-2 Remark
No. Func. Value Unit Func. Value Unit Func. Value Unit
1 ACV 0.0046 V FREQ. 0 Hz
2 ACV 0.0114 V FREQ. 0 Hz
3 ACV 0.0122 V FREQ. 0 Hz
4 ACV 0.027 V FREQ. 0 Hz
5 ACV 0.0413 V FREQ. 0 Hz
6 ACV 0.2659 V FREQ. 59.996 Hz
7 ACV 0.2724 V FREQ. 59.999 Hz
8 ACV 0.0245 V FREQ. 0 Hz
MAX 7 ACV 0.2724 V
MIN 1 ACV 0.0046 V
--- End code ---
--- End quote ---
Could you then make the app plot voltage against frequency?
EEVblog:
Can you please take this overload talk elsewhere, this thread is for firmware stuff only. Thanks.
joeqsmith:
No problem. I will clean up my mess.
About two pages cleaned up for you. If others word do the same we could get it down even lower.
jancumps:
With the v1.58 beta, I can't get the min/max/avg to work.
Pressing the button changes the AUTO label on the display, but min/max/avg don't cycle anymore for me. PEBKAC
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version