Products > Test Equipment

Open source EEZ Studio for accessing your (SCPI) instruments

<< < (29/32) > >>

kawal:

--- Quote from: prasimix on July 15, 2022, 08:39:21 am ---
Feel free to open a new feature request in GitHub: https://github.com/eez-open/studio/issues/new

--- End quote ---

prasimix
Thanks - I did - great job on EEZE studio . Its real easy to use  and very useful.

Kawal

kawal:
I found a temporary solution for my problem  - display Mhz as us Ghz as ms.

I added padding to the data and adjusted the sampling rate and timescale based on the scanned frequencies.   
If the applications allowed just to  change the units from ps=Hz   ns=kHz  us= Mhz and ms=GHz it would be 75% of my needs.



 

kawal:
making a lot of progress on the 8714ET

added  remote functions :
Averaging on/off and number of samples 1.....64
bandwidth selection  15Hz...6500Hz
Start and stop frequency  - your choice - defaults populate from current as read from instrument
Frequency center
Span
number of data points

A general setup function that will ask you of most of the settings.

Changed the padding to use the Y value of the 1st data point instead of a fixed -80dB
next  will be to stitch  graphs if more than 1601 data points are needed







CScott:
I'd like to add an instrument to EEZ Studio.  The documentation for this seems to be here https://www.envox.eu/studio/create-an-instrument-extension/project-items/settings/

My problem is that documentation seems to bear no relation to the current version of the software 0.9.97. The difference is so large that I'm not sure if there is something wrong with my installation or the documentation is out of date, or that I'm dumber than a rock.

As an example the docs show the screen for new Project Features "esp_settings-new_project.png" attached.

What I see is this "MyNewProject.jpg" attached.

There is just no correlation between these.  Can someone point me in the right direction please?

prasimix:
Hi, and sorry for huge delay in response (I never received a notification about a new message). You're completely right. The existing documentation is obsolete, but we are in the process of writing complete documentation for the latest version of EEZ Studio, so an updated version of the instructions for creating IEXT can be expected soon. Thank you for following us and for your patience.

The progress of creating new documentation can be followed at https://www.envox.eu/eez-studio-docs/

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod