« previous next »
Pages: [1]   Go Down

Author Topic: Keysight 34450A Help  (Read 263 times)

0 Members and 1 Guest are viewing this topic.

Offline Louis_CTopic starter

  • Contributor
  • Posts: 14
  • Country: us
  • Virtual lobotomies are now REAL!
    • Hamvoip RF/IP UHF repeater system
Keysight 34450A Help
« on: May 02, 2024, 04:28:25 pm »
Hello all. I'm looking for some help on a Keysight 34450A. All calibration tests pass except for 100mV AC @ 100kHz. It reads 94.837. The Low limit is 96.700 and the high is 103.3. I tried performing the internal calibration and entering the new corrected reading for this test point and the unit rejects it and fails. I flashed the firmware to the latest version available ( 01.03-01.02). I'm not sure what else to do here. Can anyone give me some advice as to what to look at next? Thanks!
Logged
I reject your reality and insert my own hyper-dimensional space. Made with real artificial ingredients.
 

Offline Simon

  • Global Moderator
  • *****
  • Posts: 17826
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
Re: Keysight 34450A Help
« Reply #1 on: May 05, 2024, 07:01:32 am »
DO NOT DOUBLE, TRIPLE....... POST. EVERYONE WILL HATE YOU.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee