Products > Test Equipment

Escort 2030 / HIOKI 7016 / EXTECH CMM-17 output calibration info needed

(1/1)

Bobson:
Escort 2030 calibration process differs from later Agilent/Keysight U1401A/U1401B.

For example, pressing SHIFT after entering Calibration mode does nothing. You need to previously select Output mode and enter Calibration mode after to get -rDy- CAL-0.

But I'm stuck in this mode, any keypresses just switch between CAL-0 and 00000 readings on the main display, no way to get further.

Any info on calibration mode of this process calibrator?

tia

P.S. Found Extech CMM-17 and AKTAKOM 7030 to be the same device.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod