| Products > Test Equipment |
| ET5410 rotary encoder issue (fixed) + thermal imaging photos |
| << < (3/3) |
| CapLeaker:
Worth mentioning that the main ground going from the plug to the transformer on the bottom was o.k... I did find that the ground from the transformer to the top plate was higher in resistance. A quick loosening and tightening of the screw on the bottom at the transformer fixed that. Since I didn't have anything better to do I swapped out the rotary encoder again and connected the DGND to GND. At the end of the day I still have kinda the same result. :rant: It's usable, but not working as it should. Aarrrgh! :palm: |
| Navigation |
| Message Index |
| Previous page |