Products > Test Equipment
ET5410 or DCL6104 or a third programmable electronic DC Load in the budget cat.?
<< < (3/5) > >>
fonak:
Hello,
I have software for DCL6204 but unfortunately I have a problem with the program, does anyone know how to fix such a bug ?





MegaVolt:
The input terminals look small for currents over 10A. Other loads have large terminals.
Hydron:

--- Quote from: fonak on March 15, 2021, 09:40:59 am ---Hello,
I have software for DCL6204 but unfortunately I have a problem with the program, does anyone know how to fix such a bug ?

--- End quote ---
I have not been able to download the software - it needs a Baidu login which I can't get. If you are willing to send me the software then I'll have a look myself.
fonak:
Hello,

Software for DCL6204
https://1fichier.com/?sozuimrehw0o6t6taekw

NiVisa driver (1.800)
https://www.ni.com/pl-pl/support/downloads/drivers/download.ni-visa.html#306041
Hydron:
Thanks for the link, I just tried it and got the same error. I will test on another computer (and also test the XP version) when I have time - probably not today unfortunately.

There is also a SCPI protocol available for the DCL8000 load, and most important commands are the same for the DCL6x04. I still have not had time to document what I tested as working, but I have some written notes that I will type up and share when I get some free time.

Edit: One of the reasons I would like to get this software going is to test if there are extra available commands that I do not know, for example to setup some of the items in the ParaSet menu like Vscale and Iscale.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod