Products > Test Equipment

ET5410 or DCL6104 or a third programmable electronic DC Load in the budget cat.?

<< < (3/5) > >>

fonak:
Hello,
I have software for DCL6204 but unfortunately I have a problem with the program, does anyone know how to fix such a bug ?





MegaVolt:
The input terminals look small for currents over 10A. Other loads have large terminals.

Hydron:

--- Quote from: fonak on March 15, 2021, 09:40:59 am ---Hello,
I have software for DCL6204 but unfortunately I have a problem with the program, does anyone know how to fix such a bug ?

--- End quote ---
I have not been able to download the software - it needs a Baidu login which I can't get. If you are willing to send me the software then I'll have a look myself.

fonak:
Hello,

Software for DCL6204
https://1fichier.com/?sozuimrehw0o6t6taekw

NiVisa driver (1.800)
https://www.ni.com/pl-pl/support/downloads/drivers/download.ni-visa.html#306041

Hydron:
Thanks for the link, I just tried it and got the same error. I will test on another computer (and also test the XP version) when I have time - probably not today unfortunately.

There is also a SCPI protocol available for the DCL8000 load, and most important commands are the same for the DCL6x04. I still have not had time to document what I tested as working, but I have some written notes that I will type up and share when I get some free time.

Edit: One of the reasons I would like to get this software going is to test if there are extra available commands that I do not know, for example to setup some of the items in the ParaSet menu like Vscale and Iscale.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod