Products > Test Equipment
Failing encoders in a Tek TDS-320 scope
<< < (6/7) > >>
Calambres:
I'm afraid it won't... besides I've already done that!  ::)
Calambres:
I quote myself  ::)

--- Quote from: Calambres on June 20, 2022, 06:05:56 pm ---Don't worry... I know myself and I'm not scrapping this. I'll do all I can to repair it. I've got used to that noisy beast  ^-^

--- End quote ---

Thanks to Simba15's warning my good ole TDS320 is alive'n'kickin' again:



Meanwhile I managed to get a brand new Siglent SDS1104X-E (now a SDS1204X-E  8)). You can see it in this picture as well as my old trusty Hameg HM203-6 analog beauty:


Calambres:
By the way... anyone know where can I find the schematics for this Tektronix TDS 320 scope?

I cannot find them no matter how much I try. Even the Service Manual for this scope is lacking the schematics!  :-\
T3sl4co1l:
They weren't made for component level repair, I'm afraid.  AFAIK.

Tim
Calambres:
Yes, I too think so. The Service Manual is full of flow diagrams to diagnose faults. They always end up with "replace board, panel, etc."  |O

The schematics must be somewhere but I'm afraid they were not meant to be publicly available. The Service manual evan has a "Diagrams" chapter which is... blank!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod