Products > Test Equipment
FeelTech FY3224S 24MHz 2-Channel DDS AW Function Signal Generator
BrokeEngineering:
Hmm I wonder if the + and -12V rails are accurate enough on this
BrokeEngineering:
Welp I finished the PSU,
Here it is if anyone has anything to comment/improve before I order it:
Schematic
Pcb View
3D Top
3D Bottom
tautech:
--- Quote from: BrokeEngineering on December 18, 2024, 12:54:00 am ---Welp I finished the PSU,
Here it is if anyone has anything to comment/improve before I order it:
--- End quote ---
Consider changing the layout in some areas to make the PCB more friendly to repair/rework hand soldering.
BrokeEngineering:
--- Quote from: tautech on December 18, 2024, 01:07:05 am ---
--- Quote from: BrokeEngineering on December 18, 2024, 12:54:00 am ---Welp I finished the PSU,
Here it is if anyone has anything to comment/improve before I order it:
--- End quote ---
Consider changing the layout in some areas to make the PCB more friendly to repair/rework hand soldering.
--- End quote ---
I am using 0805, that's as friendly as I can make it haha. I normally use 0402.
Also just did BOM cost. Its 10 USD BOM
And PCB is 2 layer less then 100*100 so each PCB comes to around 1.2 USD.
So call the entire board less then 12USD.
Which part do you think its not easy to repair?
All parts are over-specced by a minimum a factor of 2 so there should be no need to repair lol.
tautech:
--- Quote from: BrokeEngineering on December 18, 2024, 01:10:32 am ---
--- Quote from: tautech on December 18, 2024, 01:07:05 am ---
--- Quote from: BrokeEngineering on December 18, 2024, 12:54:00 am ---Welp I finished the PSU,
Here it is if anyone has anything to comment/improve before I order it:
--- End quote ---
Consider changing the layout in some areas to make the PCB more friendly to repair/rework hand soldering.
--- End quote ---
Which part do you think its not easy to repair?
--- End quote ---
L3 = rotate
R2&3 = move
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version