Products > Test Equipment

FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator

<< < (319/450) > >>

soundtec:
I did manage to get Fremens program to make a waveform and it displayed in SW V6 although the phase was reversed . When I tried a waveform created in SW V6 on Fremens again it displayed out of phase also. I havent been able to get a single waveform from any of the other programs to work on the feeltech .

soundtec:
With TTi wavemanger I was able to produce a waveform as .asc which would load into Fremens 0.7 software ,then I 'saved as'  and it sucessfully loaded and displayed in the Feeltech software . The waveforms in the TTI are based on .wfm files so maybe some kind of library exists already ,but I could only find a few extra examples of waveforms .I might try filling some of the blank spaces in the memory of the FY later on .

GregDunn:
Does anyone have anecdotal experience on where is currently the best place to buy a FY6800?  Amazon US doesn't have any yet, and something tells me this is not the time for me to start randomly selecting *Bay vendors and trusting to luck.   :P

Miti:
Banggood.

https://www.banggood.com/

precaud:

--- Quote from: GregDunn on August 07, 2018, 01:04:40 am ---Does anyone have anecdotal experience on where is currently the best place to buy a FY6800?  Amazon US doesn't have any yet, and something tells me this is not the time for me to start randomly selecting *Bay vendors and trusting to luck.   :P

--- End quote ---

I'll sell you the one I just got. I only bought it to test 14-bit arb vs 12. PM me if interested.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod