Products > Test Equipment

FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator

<< < (333/450) > >>

kirys:
is the ghost voltage gone on the 6800?
I read from this review (see the comments) https://tech.scargill.net/fy6800-signal-generator/ that the 6800 still has the ghost voltage, can someone confirm this?
Thank You
K.

soundtec:
I did read Ted's blog and wondered if the mains ground was good in his holiday home where he did the initial test .
The y cap and 1meg resistor were removed from the powersupply of the 6800 and probably newer 6600's too ,and with it all grounding through the plug I see no safety issue. I own both 66 and 68 hundred's
 

soundtec:
This guy does a good review and tear down of the 6800 ,he also does a tutorial of each of the functions of the Fy6800  and measures the leakage voltage too .



chrisjn52:
I am interested in purchasing an FY6600 or FY6800 Function Generator with a view to PC control via the NI-VISA drivers and the SCPI command language using Python & PyVisa.

As one might expect for such a low cost instrument, it does not conform to the SCPI or IEEE 488.2 specifications but I would appreciate
it if someone with more experience than I could confirm whether there would be any major issues?



GregDunn:
I may have mentioned it in an earlier post, but my 6800 has a nice IEC inlet, a fuse holder, and I measured no leakage on the outputs.  I've used it on numerous occasions and never experienced any issues with other test gear or equipment under test.  I do wish it was a little heavier so it doesn't slide when you press the buttons.   ;D

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod