Products > Test Equipment

FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator

<< < (339/450) > >>

ArsenioDev:
Hmmmm I might try my hand at making a nice open source linear drop in power supply module circuit board.

DaveR:
Hi Pio,

The KKMoon and Feeltech versions are the same product, except for the badge on the front.  The mainboard is marked 'Feeltech' in both units.  Firmware in both models on sale is probably still at 1.6 at the moment, but the latest models from the factory may already be at 1.7.  Updating from 1.6 to 1.7 is quick and simple - the KKMoon model connects to the Feeltech server and the update process is automatic once you start it via the control software.

Regards,
Dave

leftcliq:
Hi,

   Great forum.

   I know this will be a newb question but I am having a hard time changing the frequency units on the Feeltech FY6600.  Can someone please tell me button by button how I change the frequency units?  I asked the Feeltech support but go no response. 

Thanks in advance,
Dale.

bdivi:
You have to push the knob when in frequency mode.

That is you first press F1 in group 3 on your diagram and then press 6. It should change between uHz, mHz, Hz, kHz, MHz.

Cheers

DaveR:
Hi Dale - page 8 of the manual, under "ADJ Knob" :)

Dave

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod