Products > Test Equipment
FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator
<< < (421/450) > >>
fremen67:

--- Quote from: soundtec on October 01, 2019, 09:00:09 pm ---Ive been using version 5.8 of the Feeltech software , and so far find Fremens 0.8 is unusable with a 'run time error 380'
invalid property value, V 0.7 is usable but just for the basic channel functions .

--- End quote ---
That is strange, I have no problems sending waveforms to the FY6600 with the software …
The waveform file reading and editing  is a part that I did not change in the PC Software at the moment. This is still the orignal code and it might not be stable. I may have a look at it if needed.
soundtec:
The logic in the logic controls is an interesting question , seeing how its done in other popular equipment is definately a good way forward ,

Theres a question that came up before about the software catching up to changes via  the front panel , V0.7 had the update button , would it be possible for the FP to be programmed to send an equivalent update signal to the pc everytime  a value had been altered locally , it would  make sure two remotely located  opperators are reading the same true values from the instrument at all times .

0.8 Im not sure why its unstable . I'll look again tommorrow 


 



CDaniel:
Hi fremen67 , the stand-by button is not working and the red led is allways on . I don't think I have shorts , the voltage on the microcontroller pin go to GND when the I press the button so it seems fine .
fremen67:

--- Quote from: CDaniel on October 02, 2019, 09:17:03 am ---Hi fremen67 , the stand-by button is not working and the red led is allways on . I don't think I have shorts , the voltage on the microcontroller pin go to GND when the I press the button so it seems fine .

--- End quote ---


--- Quote from: fremen67 on September 22, 2019, 07:56:24 pm --- If you are interrested in testing the front panel version, I can post it. In the current version there is no buzzer, no soft power off and some views are still to be finished (configuration and system). Except from the GUI, the behaviour is the same as the bluepill version.

--- End quote ---

Correct, no buzzer neither at the moment.
soundtec:
Fremen did warn us  both those functions remained missing from the firmware in an earlier post Cdaniel,

One thing Ive noticed on the unit with the flashed Fp code was what seems to be the sine displays corrupted both on the FP display and in software ,I'll have a closer look this afternoon .
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod