Products > Test Equipment

FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator

<< < (431/450) > >>

tzok:
Will there be any updated versions of this firmware? Is is worth to flash it to a working panel (v3.2)? Chineese firmware is a little annoying, especially with changing a waveform each time WAVE button is pressed. And there is also something wrong with the amplitude of built-in half wave rectifier (but I believe firmware doesn't have anything to it).

masterx81:
Hi! One simple question. Why i see most people goes to ths3095 instead 3091? 3091 seem a bit better...
Thanks!

bdivi:
If you take the trouble to disassemble the device completely and replace the buffers I suggest you go all the way with THS3491. These are the best currently available and you can order directly from TI.

masterx81:
Aren't they a bit an overkill for a device like this?

Jacon:

--- Quote from: bdivi on February 18, 2020, 01:51:40 pm ---..... I suggest you go all the way with THS3491....
--- End quote ---
And what do you plan to do with 3491's PowerPad on this PCB, which isn't prepared for it ?   :palm:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod