Products > Test Equipment
FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator
<< < (443/450) > >>
Labrat101:
@ battlecoder

This might interest you this link.
Its a comparison of several AWG and the UTG962 & Rigol & Tek etc . Its Long and full.

https://www.element14.com/community/groups/roadtest/blog/2020/05/17/tektronix-afg31052-verification-tests
de_light:
Received a FY6900 today. Opened it up to find a v1.9 board.
They seem to have replaced the Cyclone branding on the FPGA with a "FEELELEC PRO 1941" branding  :wtf:

Edit for a pic

Labrat101:
That Just confirms what I Previously have said . Thanks.
 Total conformation that the Cyclone Chip was a Fake ..
       Maybe Intel pressed charges against them for using there Brand name.  :-DD.

  How well does the Pro 1941 chip work ?
 (typo error correction  1.7.*  The number was blurred ) 
  Sorry No Bad Feeling .
de_light:

--- Quote from: Labrat101 on November 05, 2020, 11:35:16 am ---That Just confirms what I Previously have said . Thanks.
 Total conformation that the Cyclone Chip was a Fake ..
       Maybe Intel pressed charges against them for using there Brand name.  :-DD.

  How well does the Pro 1941 chip work ?
     BTW Also my Fy68 had also had v1.9v board .
  Sorry No Bad Feeling .

--- End quote ---

If you tell me an idiot's guide to testing it, I shall do my best! My demands for a function generator aren't strenuous - purely hobbyist usage for repairing radios, driving MOSFETs etc
de_light:
I have tried to capture some images for you. Please bear in mind I am a beginner and rather cack-handedly probed the BNC centre prin output from the FY6900 with a short ground wire/spring touching the outer shell. It is NOT terminated in a 50 ohm resistance (Rigol DS1054Z)

First image is an 11 MHz square wave output, 5VDC p-p. Second is with dots and 1s persistence.

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod