Products > Test Equipment
FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator
Labrat101:
@ battlecoder
This might interest you this link.
Its a comparison of several AWG and the UTG962 & Rigol & Tek etc . Its Long and full.
https://www.element14.com/community/groups/roadtest/blog/2020/05/17/tektronix-afg31052-verification-tests
de_light:
Received a FY6900 today. Opened it up to find a v1.9 board.
They seem to have replaced the Cyclone branding on the FPGA with a "FEELELEC PRO 1941" branding :wtf:
Edit for a pic
Labrat101:
That Just confirms what I Previously have said . Thanks.
Total conformation that the Cyclone Chip was a Fake ..
Maybe Intel pressed charges against them for using there Brand name. :-DD.
How well does the Pro 1941 chip work ?
(typo error correction 1.7.* The number was blurred )
Sorry No Bad Feeling .
de_light:
--- Quote from: Labrat101 on November 05, 2020, 11:35:16 am ---That Just confirms what I Previously have said . Thanks.
Total conformation that the Cyclone Chip was a Fake ..
Maybe Intel pressed charges against them for using there Brand name. :-DD.
How well does the Pro 1941 chip work ?
BTW Also my Fy68 had also had v1.9v board .
Sorry No Bad Feeling .
--- End quote ---
If you tell me an idiot's guide to testing it, I shall do my best! My demands for a function generator aren't strenuous - purely hobbyist usage for repairing radios, driving MOSFETs etc
de_light:
I have tried to capture some images for you. Please bear in mind I am a beginner and rather cack-handedly probed the BNC centre prin output from the FY6900 with a short ground wire/spring touching the outer shell. It is NOT terminated in a 50 ohm resistance (Rigol DS1054Z)
First image is an 11 MHz square wave output, 5VDC p-p. Second is with dots and 1s persistence.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version