| Products > Test Equipment |
| FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator |
| << < (445/450) > >> |
| RainerB:
I'm plaing with fremen67's Bluepill Code V0.82. An ILI9341 Display and the serial PC connection worked. The keypad doesn't really worked, not sure if this version support (all) keys. The PB2 Pin is not available on the Bluepill. Can anybody give me some additional information about the bluepill version? I send fremen67 a pm a few days ago, but didn't got any feedback yet. Thanks and regards Rainer |
| mnementh:
Considering that the FY6x00 are all available right now within a few dollars of the UTG 9x2, at around US$100 (the days of the $40 FY6600 are long gone), and only aboot $75 less than the PSG8090 even with "Black Friday" sales, is the PSG8090 now the best bang/buck? I like the form factor of the UTG 9x2, as it would fit under my scope with the bail down (pretty sure that's why these were made this way); but it is pretty hard to make even a ballpark evaluation of these 3 families of "Chinesium Cheapies", except that the FY6900 seems to be pretty roundly disliked as a downgrade from previous versions. :P One thing that would make my decision easier... can the 9x2 be easily modded with an external +/-15V supply? I mean, without just munging the eff out of the board...? mnem :popcorn: |
| mnementh:
Pulled the trigger on a UTG 962 from bang-em-good; was able to burn a few affiliate points and saved a few dollars. Might be here before X-mas; we'll see how it fares then. mnem ;D |
| Falk:
To whom it may concern. https://www.mikrocontroller.net/articles/FY6900 Sorry, only in german. Njoy |
| cepsbow:
I really appreciate the efforts here guys. :-+ I got my FY6600 while they were on sale, and have been steadily modding it as I went. Before I went into the FP, wanted to know if there is access to the source for the mcu and whatnot? And can you flash this over the stock micros firmware? For information my FY6600 came with version 3.3 hardware and a FEELELEC PRO FPGA. I need to pour over the ICs and match them up to the models you guys posted. Has anyone heard from fremen lately? |
| Navigation |
| Message Index |
| Next page |
| Previous page |