Products > Test Equipment
FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator
<< < (449/450) > >>
hlj.pycad:
I fixed the last problem. It's PSU output caps' problem.

But some how my "sinewave" became 3/4 sine+1/4square.... it's there a fix for this?
Atlan:
Repair sine with program?
hlj.pycad:
Yes. I just found that. Thank you.
hlj.pycad:
I want to calibrate FY6600-15M with Fremen67's PC software, with no success. Can I do calibration with stock hardware or it's only for modified BluePill Front Panel?

When I switch to "Calibartion" page, it's really slow and slugish. After 1minute or 2 minute, the UI show but every input box turn to 0.000 one by one as follow:

And any calibartion attempt will fail as the same error:


I tried it in a fresh Win7 virtual machine, so what's the problem?
tzok:

--- Quote from: hlj.pycad on June 14, 2024, 03:37:55 pm ---I want to calibrate FY6600-15M with Fremen67's PC software, with no success. Can I do calibration with stock hardware or it's only for modified BluePill Front Panel?
--- End quote ---
It is only for the modified Front Panel firmware (as mentioned in the window title).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod