Products > Test Equipment

FeelTech FY6600 60MHz 2-Ch VCO Function Arbitrary Waveform Signal Generator

<< < (449/450) > >>

hlj.pycad:
I fixed the last problem. It's PSU output caps' problem.

But some how my "sinewave" became 3/4 sine+1/4square.... it's there a fix for this?

Atlan:
Repair sine with program?

hlj.pycad:
Yes. I just found that. Thank you.

hlj.pycad:
I want to calibrate FY6600-15M with Fremen67's PC software, with no success. Can I do calibration with stock hardware or it's only for modified BluePill Front Panel?

When I switch to "Calibartion" page, it's really slow and slugish. After 1minute or 2 minute, the UI show but every input box turn to 0.000 one by one as follow:

And any calibartion attempt will fail as the same error:


I tried it in a fresh Win7 virtual machine, so what's the problem?

tzok:

--- Quote from: hlj.pycad on June 14, 2024, 03:37:55 pm ---I want to calibrate FY6600-15M with Fremen67's PC software, with no success. Can I do calibration with stock hardware or it's only for modified BluePill Front Panel?
--- End quote ---
It is only for the modified Front Panel firmware (as mentioned in the window title).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod