Products > Test Equipment
FeelTech FY8300s Firmware update fail
(1/3) > >>
XTRAC:
I initiated a firmware update to a FY8300s using the latest FeelElec Waveform Generator PC software posted to their website 2024-01-28 09:42:47, version 7.8.
The update was taking a long time so I left it over night and it was still updating in the morning so I aborted the software and turned off the FY8300s. Not supposed to do that I know but what do you do? Now, when I turn it on, there is a clicking noise, a blank screen, and the three channel lights are ON. No response from keypad or usb.
Is there any way to fix this one?

Zenith:
A firmware update shouldn't take more than a few minutes at most.

Have you emailed FeelElec? There might be some factory reset that lets you unscramble things, at least to the extent of being to retry a firmware load.
XTRAC:
I will contact FeelTech and post the response here if I get one.
Atlan:
I tried to send an answer that it cannot be delivered.  Some problem with the server
Zenith:
No doubt forum member FeelElec will be along some time soon to advise, and ensure that your customer support experience is flawless. Or perhaps not, as the case may be.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod