Products > Test Equipment
Finally! Hantek HDM3065 6.5 Digit DMM
<< < (23/24) > >>
jezgb:
Yep - that's exactly what I (hadn't!) done.    :palm:

Thanks!

 ;D
ali_asadzadeh:

--- Quote ---Just got the new firmware for the HDM3065(B). It looks like Hantek have fixed the issue that caused a spike reading at ~36min of logging.
--- End quote ---
Thanks for sharing, I have updated my unit right now ^-^
Sairus:
Does anyone try add parts to get LXI?
Probably just RJ45 socket, ethernet transformer and some passive components needed.
Settings are available in menu and why not give a try.

So if anyone can do pictures of PCB with populated parts please share it here.
sfs1:
I saw the cal cert in SteveyG's video and experienced deja vu....



Microcheap:

--- Quote from: Sairus on June 01, 2024, 09:36:55 am ---Does anyone try add parts to get LXI?
Probably just RJ45 socket, ethernet transformer and some passive components needed.
Settings are available in menu and why not give a try.

So if anyone can do pictures of PCB with populated parts please share it here.


--- End quote ---

Yes, I did add the missing parts to my HDM3065 and it can connect to a LAN without problems.

You will just need to solder the LAN connector, a 1:1 LAN transformer, some 0603 resistors and 0805 capacitors. That's all, no other change in FW or HW is required. I have attached pictures with the components values for reference.

The process is straight forward, but you will need to completely remove the main board to solder the resistors and capacitor on the bottom. Just unscrew the top cover and the front panel for that.

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod