Products > Test Equipment
Finally! Hantek HDM3065 6.5 Digit DMM
Sairus:
--- Quote ---Yes, I did add the missing parts to my HDM3065 and it can connect to a LAN without problems.
You will just need to solder the LAN connector, a 1:1 LAN transformer, some 0805 resistors and capacitors. That's all, no other change in FW or HW is required. I have attached pictures with the components values for reference.
The process is straight forward, but you will need to completely remove the main board to solder the resistors and capacitor on the bottom. Just unscrew the top cover and the front panel for that.
--- End quote ---
Big thanks for your repply Microcheap.
Actualy I made some research and findout that there are instaled SMSC8710A LAN controller on display board.
Then I read manual and ordered some parts.
Your reply gave me extra confidence in my component values chouse so I wait for delivery and then I did it.
and it working.
My parts list:
R182,R183,R184,R185 - 49.9Ohm - 0603
R191,R192 - 75Ohm - 0603
R198,R199 - 300Ohm - 0603
C125 - 1uF - 16V - 0805
T2 - H1102NL
J4 - L-KLS12-108-8P8C-1X1-2-Y/G-0-01
Total price ~ 7$
xduan:
I recently bought an hdm3065b, I used its usb interface, but it doesn't allow me to use the multimeter's physical buttons, in addition to the interface being slow, I wanted to know if there is a way to just transmit the image of the multimeter's screen to the PC for monitoring and maybe put In obs studio, I tried connecting via LXI through the browser but when entering the IP only some text information appears.
Navigation
[0] Message Index
[*] Previous page
Go to full version