| Products > Test Equipment |
| Finally! Hantek HDM3065 6.5 Digit DMM |
| << < (8/24) > >> |
| voltsandjolts:
--- Quote from: Marco Camara on December 05, 2021, 01:29:52 pm ---I'm not planning to open the multimeter. --- End quote --- How will you replace the 10A fuse? |
| voltsandjolts:
Writing a comprehensive and accurate design specification for this unit must have been easy - here, copy this! |
| Marco Camara:
It's a good question! I didn't blow it yet, but you're right - if I need to open the equipment to change the fuse, than there's no problem if I open it. |
| knudch:
Have you read this section in the manual ? Page 18 of the manual "Note: the large current input fuse is located inside the instrument and is not allowed to 18 be replaced by the user. If needing replacement, please contact Qingdao Hantek Electronic Co., Ltd." |
| Marco Camara:
Thanks for alerting me! I hadn't seen this detail... So, the equipment will remain closed, at least until the end of the warranty... I'm sorry, folks, I won't open it. |
| Navigation |
| Message Index |
| Next page |
| Previous page |