| Products > Test Equipment |
| Finally! Hantek HDM3065 6.5 Digit DMM |
| << < (9/24) > >> |
| voltsandjolts:
--- Quote from: knudch on December 05, 2021, 02:44:47 pm ---Have you read this section in the manual ? Page 18 of the manual "Note: the large current input fuse is located inside the instrument and is not allowed to 18 be replaced by the user. If needing replacement, please contact Qingdao Hantek Electronic Co., Ltd." --- End quote --- Wow, what BS is this. |O :-- Please pretend you have blown fuse in your unit in Brazil and ask them - do they expect you to pay for shipping to and service in China? |
| knudch:
I must admit that such requirement would be a absolute negative feature in my perspective What was the price compared to Siglent SDM 3065X ? Just got that meter |
| Marco Camara:
They have authorized service here in Brazil, but even so, if I blow the fuse, I think I WILL OPEN IT ;) What I don't want to do is open it just to take photos. Yes, I'm curious too, but if I have any problem in theses 3 first years, I'm afraid to loose the warranty. Knudch, I evaluated Siglent, even because I already have one of their Function Generator, but the SDM3065 would cost about 50% more than Hantek option here in Brazil. As I also have a Hantek oscilloscope, and the product price was better, I chose to bet on Hantek. |
| knudch:
50% compared to SDM3065X is a sum of money :) |
| Marco Camara:
Hi, I have some new information about the HDM3065. I have finally tested USB and ethernet connections. The HDM3065 (model B) can communicate using any of the two ports with no problems. It wasn't easy to configure, as there are no information at manual. The Hantek support team helped, but I had to discover some information by myself. I have installed the Hantek software. It's a type of "remote control" of the equipment. It shows a copy of the front panel, and you can access most of the function buttons, but not all of them. I have also tested SCPI commands. That's the feature I wanted to use with the ethernet connection. It works fine, even using just a telnet connection with the equipment. |
| Navigation |
| Message Index |
| Next page |
| Previous page |