Products > Test Equipment

finding short on motherboards with a shorty (with display)

<< < (28/37) > >>

Miti:
Here it is.

Lagros:
Try unsoldering R10 and R11 and turn it on without these resistors.

Miti:

--- Quote from: Lagros on February 08, 2024, 01:33:55 pm ---Try unsoldering R10 and R11 and turn it on without these resistors.

--- End quote ---

How would it work without pull-up resistors? What do you suspect?

Lagros:
Pull-up resistors are present in OLED.
Try it!

Ocela:

--- Quote from: Miti on February 06, 2024, 08:10:07 pm ---I don’t think Jiri is still maintaining this project.
I installed STM32 Cube and tried to change the I2C mode from FastModePlus to FastMode but I can’t figure out how to do that.  :palm:
Moreover, the project doesn’t seem to be the latest one. I guess I’m  :horse:

--- End quote ---
Miti, this is not enough. It is also necessary to change the frequencies inside the microcontroller buses
The pull-up resistors for the I2C bus and 3.3V voltage are not selected correctly. They should be equal to 1k. You can calculate this using an online calculator.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod